Filter
Top Products
74 Operation, Safety
O - Initial position
1 - Ignition on
2 - Start engine
3 - Ignition off
Ignition/Starter Switch with
anti-theft Steering Lock
The ignition lock has a total of four ignition lock po-
sitions.
The ignition key rebounds to the initial position
from every ignition lock position.
f For your safety, fasten safety belts.
f Please see the chapter “IMMOBILIZER” on
Page 15.
f Please see the chapter “KEY WITH RADIO RE-
MOTE CONTROL” on Page 16.
Before starting the engine
f Apply the footbrake.
f Manual transmission:
Move the gearshift lever into neutral.
The clutch pedal must be depressed fully
before the starter will engage.
f In vehicles with PDK transmission:
Move PDK selector lever to position P or N.
Switch position 0
Initial position
The ignition key cannot be withdrawn when the
ignition is switched on or when the engine has
been started.
To withdraw the ignition key:
f Stop the vehicle.
f In vehicles with PDK transmission:
Move PDK selector lever to position P.
f Switch ignition off.
f Remove ignition key.
Switch position 1
Ignition on
f Turn ignition key to position 1.
Ignition is switched on.
Note on operation
All electrical equipment can be switched on.
f Please see the chapter “WARNINGS ON THE
INSTRUMENT PANEL AND THE ON-BOARD
COMPUTER” on Page 158.