Filter
Top Products
ENGLISH
36
Checking and adjusting the choke cable play *
The choke lever must always have a play of approx. 4 mm (0,16 in).
Remove the seat and tank to adjust.
Push the choke lever all the way to the front and slide the protecting cap
1
from the adjusting part 2.
Loosen the lock nut
3 and correct the play by turning the adjusting part.
Tighten lock nut and slide protecting cap back on.
Mount the tank and seat.
Checking the adjustment of the hand decompression cable*
To check, set piston at compression, so that the valves are closed. While
doing this, slowly operate the kickstarter through its stroke until the clicking
sound (disengaging) of the automatic decompression can be heard. Now
the decompression lever must be operated 25 mm (1 in) until resistance is
felt (the exhaust valves begin to open). To adjust move back the protective
cover
4, loosen the counter nut and correct the adjusting screw 5
accordingly. Tighten counter nut and push back protective cover.
!
CAUTION
!
I
F THERE IS NO PLAY IN THE DECOMPRESSION LEVER, THIS CAN RESULT IN ENGINE
DAMAGE
.
NOTE:
No adjustment need be made to the automatic decompressor.
Adjust idling speed *
Use the adjusting screw
6
to adjust the basic position of the throttle valve
and, thus, the idle speed.Turning in clockwise direction will increase the
idling speed, turning in counterclockwise direction will reduce the idling
speed. Normal idling speed 1400 - 1500 rpm.
1
2
4 mm
3
6
25 mm
4
5