KTM 450 XCR-W ZA Motorcycle User Manual


 
MAINTENANCE WORK ON CHASSIS AND ENGINE 69
Removing a fuse
Switch off all power-consuming components and switch off the engine.
Dismount the air filter box lid. ( P. 74)
400270-10
Remove the protection coverb.
Info
The fusebis located in the starter relayb under the filter box cover.
Remove the fuseb
.
Replacing the fuse
Warning
Fire hazardThe electrical system can be overloaded by the use of incorrect fuses.
Use only fuses with the prescribed amperage. Never by-pass or repair fuses.
400273-10
Check parts for damage and wear. Replace damaged or worn parts.
Info
A reserve fusebis located in the starter relay.
Replace a burned-out fuseb
only by an equivalent fuse.
Refit the fuse.
Fuseb(58011109110)
Info
If the new fuse burns out, contact an authorized KTM workshop.
Replace the protection cover.
Install the air filter box lid. ( P. 74)
Removing the seat
500080-10
Remove screwb. Lift up the seat at the rear, pull it back and then remove from
above.
Mounting the seat
500068-01
Check parts for damage and wear. Replace damaged or worn parts.
Hook the front of the seat into the flange adapter of the fuel tank, lower the rear of
the seat and simultaneously push it forwards.
Make sure that the seat is correctly locked in.
Mount and tighten the screw of the seat fixing.
Specification
Remaining screws, chassis M6 10bNm (7.4blbfbft)