KTM 450 XCR-W ZA Motorcycle User Manual


 
00BB
00BB
00AA
00AA
MAINTENANCE WORK ON CHASSIS AND ENGINE 47
Refitting the headlight mask with the headlight (EXC-RbEU, EXC-RbAUS/UK, EXC-RbSIXbDAYS, EXC-RbUSA,
XCR-WbZA)
500156-11
Check parts for damage and wear. Replace damaged or worn parts.
Connect the electric plug connectorb
.
500155-11
Position the headlight mask and fix it with the rubber bandb.
Info
Take care with the contact of the holding lug at the fender.
Position the brake line and cable harness. Put the clamp on, mount and tighten
screwb
.
Check the headlamp setting.
Dismount the start number plate (XCR-WbUSA)
500101-10
Remove screwband take off clamp.
Remove screwb
with distance bushing. Remove the start number plate.
Fitting the start number plate (XCR-WbUSA)
500101-11
Check parts for damage and wear. Replace damaged or worn parts.
Position the start number plate. Fit and tighten screwb
with distance bushing.
Specification
Remaining screws, chassis M6 10bNm (7.4blbfbft)
Info
Take care with the contact of the holding lug at the fender.
Position the brake line and cable harness. Put the clamp on, mount and tighten
screwb
.
Handlebar position
400223-11
On the upper triple clamp, there are 2 holes at a distance ofbto each other.
Distanceb
between holes 15bmm (0.59bin)
The holes on the handlebar support are placed at a distance ofb
from the center.
Distanceb
between holes 3.5bmm (0.138bin)
The handlebar supports can be mounted in 4 different positions.
(EXC-RbSIXbDAYS)
The handlebar supports can also be mounted at 2 different heights (with and with-
out spacer).
Thick spacer 9bmm (0.35bin)