KTM 450 XCR-W ZA Motorcycle User Manual


 
MAINTENANCE WORK ON CHASSIS AND ENGINE 46
Greasing the steering head bearingbx
(EXC-RbSIXbDAYS, XCR-WbUSA)
Remove the lower triple clamp. ( P. 43)
Install the lower triple clamp. ( P. 44)
(EXC-RbEU, EXC-RbAUS/UK, EXC-RbUSA, XCR-WbZA)
Remove the lower triple clamp. ( P. 44)
Install the lower triple clamp. ( P. 45)
Dismounting the front fender
500092-10
Remove screwsb. Remove the front fender.
Make sure that the distance bushings remain in place.
Installing the front fender
500092-10
Check parts for damage and wear. Replace damaged or worn parts.
Make sure that the distance bushings are mounted in the fender.
Position the front fender. Mount and tighten screwsb
.
Specification
Remaining screws, chassis M6 10bNm (7.4blbfbft)
Info
Ensure that there is contact between the holding lugs and the start number
plate or headlight mask.
Removing headlight mask with headlight (EXC-RbEU, EXC-RbAUS/UK, EXC-RbSIXbDAYS, EXC-RbUSA, XCR-WbZA)
500155-10
Switch off all electrical equipment.
Remove screwb
and take off clamp.
Loosen the rubber bandb
. Push up the headlight mask and swing it forwards.
500156-10
Pull out the electric plug connectorb and remove the headlight mask with the
headlight.