KTM 450 XCR-W ZA Motorcycle User Manual


 
MAINTENANCE WORK ON CHASSIS AND ENGINE 61

Adding rear brake fluidb
x
Warning
Danger of accidentsBrake system failure.
If the brake fluid level falls below the MIN mark, this indicates a leakage in the brake system or worn-out brake linings.
Have the brake system checked in an authorized KTM workshop, and do not ride any further.
Warning
Skin irritationsBrake fluid can cause skin irritation on contact.
Avoid contact with skin and eyes, and keep out of the reach of children.
If brake fluid gets into your eyes, rinse thoroughly with water and contact a doctor immediately.
Warning
Danger of accidentsReduced braking due to old brake fluid.
Have the front and rear brake fluid replaced according to the service plan in an authorized KTM workshop.
Warning
Environmental hazardProblem materials cause environmental damage.
Dispose of oil, grease, filters, fuel, cleaning substances, brake fluid, batteries, etc. according to regulations.
Info
KTM recommends brake fluid DOTb5.1 frombMotorex
®
. This brake fluid has a higher wet boiling point than brake fluid DOTb4
and offers more protection under high load.
Never user DOTb5 brake fluid! This is based on silicone oil and is colored purple. Oil seals and brake lines are not designed for
DOTb5 brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint!
Use only clean brake fluid from a sealed container!
400233-10
Stand the vehicle upright.
Remove screw capb
with membraneb and the O-ring.
Add brake fluid to levelb
.
Brake fluid DOT 5.1 ( P. 114)
Check parts for damage and wear. Replace damaged or worn parts.
Mount the screw cap with the membraneband the O-ring.
Info
Clean up overflowed or spilt brake fluid immediately with water.

Checking rear brake linings
Warning
Danger of accidentsReduced braking due to worn brake linings.
Worn brake linings should be replaced immediately in an authorized KTM workshop.
400238-10
Check the brake linings for minimum thicknessb.
» Minimum thicknessb
: ุb1bmm (ุb0.04bin)
If the minimum thickness is less than specified:
Change the rear brake linings. ( P. 63)