KTM 450 XCR-W ZA Motorcycle User Manual


 
MAINTENANCE WORK ON CHASSIS AND ENGINE 63

Changing the rear brake liningsb
x
Warning
Skin irritationsBrake fluid can cause skin irritation on contact.
Avoid contact with skin and eyes, and keep out of the reach of children.
If brake fluid gets into your eyes, rinse thoroughly with water and contact a doctor immediately.
Warning
Danger of accidentsReduced braking due to old brake fluid.
Have the front and rear brake fluid replaced according to the service plan in an authorized KTM workshop.
Warning
Environmental hazardProblem materials cause environmental damage.
Dispose of oil, grease, filters, fuel, cleaning substances, brake fluid, batteries, etc. according to regulations.
Info
KTM recommends brake fluid DOTb5.1 from Motorex
®
. This brake fluid has a higher wet boiling point than brake fluid DOTb4
and offers more protection under high load.
Never user DOTb5 brake fluid! This is based on silicone oil and is colored purple. Oil seals and brake lines are not designed for
DOTb5 brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint!
Use only clean brake fluid from a sealed container!
400233-10
Remove the rear brake linings. ( P. 62)
Stand the vehicle upright.
Remove screw capb
with membraneb and the O-ring.
Press the brake piston back to its basic position and make sure that no brake fluid
overflows from the brake fluid reservoir.
Install the rear brake linings. ( P. 62)
Add brake fluid to levelb
.
Brake fluid DOT 5.1 ( P. 114)
Check parts for damage and wear. Replace damaged or worn parts.
Mount the screw cap with the membraneband the O-ring.
Info
Clean up overflowed or spilt brake fluid immediately with water.

Removing front wheelb
x
Jack up the motorcycle. ( P. 32)
500089-10
Press the brake caliper by hand on to the brake disc in order to press back the
brake pistons.
Info
Make sure when pushing back the brake pistons that you do not press the
brake caliper against the spokes.
500084-10
Remove screwb.
Loosen screwb
.