KTM 450 EXC-R EU, 450 EXC-R AUS/UK, 450 EXC-R SIX DAYS, 450 EXC-R USA, 450 XCR-W UsA, 450 XCR-W ZA, 530 EXC-R EU, 530 EXC-R AUS/UK, 530 EXC-R SIX DAYS, 530 EXC-R USA, 530 XCR-W USA, 530 XCR-W ZA Motorcycle User Manual


  Open as PDF
of 125
 
0022
0011
0022
0011
00
33
00
22
00
11
0044
0055
0066
0077
0088
0099
MAINTENANCE WORK ON CHASSIS AND ENGINE
48

Adjusting handlebar positionbx
400223-10
(EXC-RbEU, EXC-RbAUS/UK, EXC-RbUSA, XCR-W)
ದ Remove the four screwsb
. Remove the handlebar clamp. Remove the handle-
bar and lay it to one side.
Info
Protect the motorcycle and its attachments from damage by covering
them.
Do not bend the cables and lines.
ದ Remove the two screwsb
. Remove the handlebar support.
ದ Check parts for damage and wear. Replace damaged or worn parts.
ದ Place the handlebar support in the required position. Fit and tighten the two
screwsb
.
Specification
Screw, handlebar support M10 40bNm
(29.5blbfbft)
Loctite
®
243™
Info
Position the left and right handlebar supports evenly.
ದ Position the handlebar.
Info
Make sure cables and wiring are positioned correctly.
ದ Position the handlebar clamp. Fit and evenly tighten the four screwsb
.
Specification
Screw, handlebar clamp M8 20bNm
(14.8blbfbft)
Info
Make sure the gap width is even.
400343-10
(EXC-RbSIXbDAYS)
ದ Remove the four screwsb
. Remove the handlebar clampsb
with rubber wash-
ersb
and elastomersb
.
ದ Remove the handlebar and lay it to one side.
Info
Protect the motorcycle and its attachments from damage by covering
them.
Do not bend the cables and lines.
ದ Remove the lower shellsb
.
ದ Remove the clamp barb
with the rubber conesb
.
ದ Remove the two screwsb
. Remove the handlebar support.
ದ Check parts for damage and wear. Replace damaged or worn parts.
 previous next