KTM 450 EXC-R EU, 450 EXC-R AUS/UK, 450 EXC-R SIX DAYS, 450 EXC-R USA, 450 XCR-W UsA, 450 XCR-W ZA, 530 EXC-R EU, 530 EXC-R AUS/UK, 530 EXC-R SIX DAYS, 530 EXC-R USA, 530 XCR-W USA, 530 XCR-W ZA Motorcycle User Manual


 
MAINTENANCE WORK ON CHASSIS AND ENGINE 80
200112-10
Place a suitable container under the engine.
Remove engine oil plug screenb
.
Completely drain the engine oil.
Thoroughly clean the plug and gear oil screen.
Clean the sealing area on the engine.
Check parts for damage and wear. Replace damaged or worn parts.
Fit plugb
for the engine oil screen and tighten it.
Specification
Plug, engine oil screen M17x1,5 20bNm
(14.8blbfbft)

Removing the oil filterb
x
Warning
Danger of scaldingEngine oil and gear oil get very hot when the motocycle is driven.
Wear suitable protective clothing and gloves. If you scald yourself, hold the affected area under cold water immediately.
Warning
Environmental hazardProblem materials cause environmental damage.
Dispose of oil, grease, filters, fuel, cleaning substances, brake fluid, batteries, etc. according to regulations.
Place a suitable container under the engine.
200113-10
Remove screwsb. Remove oil filter coverb with O-ring.
200114-10
Pull the oil filter insertb out of the oil filter casing.
Circlip pliers reverse (51012011000)
Completely drain the engine oil.
Thoroughly clean parts and sealing area.

Mounting oil filterb
x
200114-11
Check parts for damage and wear. Replace damaged or worn parts.
Lay the motorcycle on its side and fill the oil filter housing to about 1/3 full with
engine oil.
Fill the oil filterb
with engine oil and place it in the oil filter container.
Lubricate the O/ringb
of the oil filter cover.