KTM 450 EXC-R EU, 450 EXC-R AUS/UK, 450 EXC-R SIX DAYS, 450 EXC-R USA, 450 XCR-W UsA, 450 XCR-W ZA, 530 EXC-R EU, 530 EXC-R AUS/UK, 530 EXC-R SIX DAYS, 530 EXC-R USA, 530 XCR-W USA, 530 XCR-W ZA Motorcycle User Manual


 
MAINTENANCE WORK ON CHASSIS AND ENGINE 54
Adjusting chain tension - fitting rear wheel
400225-11
Loosen nutsb.
Adjust the chain tension by turning the adjusting screwsb
left and right.
Specification
Chain tension 8… 10bmm (0.31… 0.39bin)
Turn the adjusting screwsb
left and right so that the markings on the left and
right chain adjusters are in the same position relative to the reference marksb
.
The rear wheel is then correctly aligned.
Tighten nutsb
.
Adjusting chain guidebx
400252-10
Remove screwsbandb. Take off the chain guide.
Conditions
Number of teeth: ืb44bteeth
Insert nutb
in holeb. Position the chain guide.
Mount and tighten screwsb
andb.
Specification
Remaining screws, chassis M6 10bNm
(7.4blbfbft)
Conditions
Number of teeth: ุb45bteeth
Insert nutb
in holeb. Position the chain guide.
Mount and tighten screwsb
andb.
Specification
Remaining screws, chassis M6 10bNm
(7.4blbfbft)
Brake fluid reservoir
Warning
Danger of accidentsBrake system failure.
If the brake fluid level falls below the MIN mark, this indicates a leakage in the brake system or worn-out brake linings.
Have the brake system checked in an authorized KTM workshop, and do not ride any further.
The brake fluid reservoirs of the front and rear brakes are dimensioned so that they do not need topping up with brake fluid even if the
brake linings are worn.