Kenwood DNX571EX GPS Receiver User Manual


 
120120
Return to the Top page
Remote control
Remote control
This unit can be operated using the remote control.
For DNX891HD, DNX7710BT, DNX691HD, and DNX5710BT, the remote control is supplied with
the unit.
For DNX771HD, DNX571HD and DNX571EX the remote control is the optional accessory (KCA-
RCDV331).
2CAUTION
• Put the remote control in a place where it will not move during braking or other operations. A
dangerous situation could result, if the remote control falls down and gets wedged under the pedals
while driving.
• Do not leave the battery near fire or under direct sunlight. A fire, explosion or excessive heat
generation may result.
• Do not recharge, short, break up or heat the battery or place it in an open fire. Such actions may cause
the battery to leak fluid. If spilled fluid comes in contact with your eyes or on clothing, immediately
rinse with water and consult a physician.
• Place the battery out of reach of children. In the unlikely event that a child swallows the battery,
immediately consult a physician.
Battery Installation
If the remote control operates only over shorter distances or does not operate at all, it is possible
that the batteries are depleted.
In such instances, replace the both batteries with new ones.
1 Insert two “AAA”/“R03”-size batteries with the and poles aligned properly, following
the illustration inside the case.