Filter
Top Products
53
Audio Menu
You can select digital signal type through the DIGITAL OUT
terminal.
On the Audio menu, you can set the following:
D Digital
DTS
MP3
CD
Off
Off
Off
Off
Next Page
Language
Picture Audio Setting Rating
Setting Menu
You can make the speaker settings according to the size and layout
of your speakers.
On the Setting menu, you can set the following:
Dynamic Range:You can enjoy a powerful sound at night even at
a low volume level when listening to the sound
with Dolby Digital.
• On: Select this when you want to apply the
compression effect fully (useful at midnight.)
• Off: Select this when you want to enjoy surround
with its full dynamic range (no effect
applied.)
C.Delay: To register delay time for center speaker—from
0 msec to 5 msec. See “Setting the delay time”
on the next page.
R.Delay: To register delay time for rear speakers—from 0
msec to 15 msec. See “Setting the delay time”
on the next page.
Speaker Set: Enters Speaker setting sub-menu. See “Speaker
setting” on the next page.
Test Tone: The test tone menu appears on the TV and the
test tone comes out from the speakers in the
order. See “Adjusting the Sound” on page 23.
• If a disc is not loaded, the test tone does not
come out.
• If there is a speaker from which no sounds
comes out, check the speaker’s connection (see
pages 6 and 7.)
Dynamic Range
C.Delay
S.Delay
Speaker Set
Off
0 ms
0 ms
LR C LS RS SW
Test Tone
Language
Picture Audio Setting Rating
D Digital / DTS:
• PCM: Select this when you connect to the DIGITAL
OUT terminal to the linear PCM digital input
of other audio equipment.
• STREAM: Select this when you connect to the digital
input of an amplifier to a built-in Dolby
Digital or DTS multichannel decoder.
• Off: Do not out signals in DIGITAL OUT
terminal.
MP3:
• Off: Do not out signals in DIGITAL OUT
terminal.
CD / PCM:
• PCM: Select this when you connect to the DIGITAL
OUT terminal to the linear PCM digital input
of other audio equipment.
• Off: Do not out signals in DIGITAL OUT
terminal.
DownSampling:
• On: Select this when you need to downsample the
digital output signal.
• Off: Select this when you do not need to
downsample the digital output signal.
EN50-55TH-A35[A].pm6 03.5.12, 7:48 PM53