Filter
Top Products
8
Getting started
For TV and video format
This receiver cannot convert the video signals. When the video
signal of one video component is different from that of the other
(for example, one is S-video, the other is Composite), you may
not see the pictures appropriately. In this case, unify the video
signals of all the video components, or you need to switch the
video signal of TV each time you change the source.
For an analogue decoder
To watch through or to record a scrambled program on your
VCR, connect the analogue decoder to your VCR and select the
scrambled channel on your VCR.
If there is not an appropriate terminal for the decoder connection
on your VCR, connect the decoder to your TV.
Refer also to the manuals supplied with these components.
For T-V LINK
• You can use the T-V LINK function if you connect a T-V LINK
compatible TV and VCR to this receiver with a fully wired
SCART cables. For details on T-V LINK, refer also to the
manuals supplied with the TV and the VCR.
• Connect a SCART cable to EXT-2 terminal on the JVC’s T-V
LINK compatible TV for the T-V LINK function.
• Some video components support the data communication like
T-V LINK. For complete details, refer also to the manuals
supplied with these components.
Y
AUDIO
P
B
P
R
VIDEO S-VIDEO
SUB-
WOOFER
DVR/DVD
IN
MONITOR
OUT
RIGHT LEFT
SURR-LSURR-R
CENTER
VIDEO
IN
DVD
MULTI IN
VIDEO
COMPONENT
Å
ı
Å To component video output
ı To left/right audio channel output
NOTES
• Connect Y, PB, and PR correctly.
• Do not connect different components to the AUDIO DVR/DVD
IN jacks and AV IN/OUT (SCART) DVR/DVD terminal (see page
7); otherwise, sounds from both components are come out of
the speakers at the same time.
DVD recorder or DVD player
Audio/video connection
In addition to the SCART terminals, this receiver is equipped with the following video terminals:
• Component video input/output: VIDEO IN, DVR/DVD IN, MONITOR OUT
• Composite and S-video input: VIDEO IN
IMPORTANT
The component video signals from the COMPONENT jacks are transmitted only through the MONITOR OUT jacks.
Therefore, if the TV is connected to the receiver through the SCART terminal (TV) and a playing video component is connected to the
receiver through the component video jacks (VIDEO IN or DVR/DVD IN), you cannot view the playback picture on the TV.
7 Connecting a DVD recorder or DVD player to the DVR/DVD IN jacks
To fully enjoy Dolby Digital and DTS multi-channel software (including Dual Mono software), connect the DVD recorder or DVD player
through the digital input terminals (see page 11).
When you connect a DVD recorder or DVD player with its stereo output jacks:
Stereo audio cable
(not supplied)
Green
Blue
Red
Component video cable
(not supplied)
Turn off all components before making
connections.
White
Red
06-11RX-F10[B]_f.p65 04.2.13, 16:408