Filter
Top Products
62-86-25-14
Quick Start Guide for Herculine 2000 Series Actuators
February 2007
Page 7 of 10
Step Operation Press Result
4
Select other
function
parameters
FUNCTION
Successive presses of the FUNCTION key will sequentially display the other function
prompts of the selected set up group.
Stop at the function prompt that you want to change, and then proceed to the next step.
5
Change the
Value or
Selection
or
These keys increase or decrease the value, or display the next available selection for the
selected function prompt.
Change the value or selection to meet your needs.
NOTE: If the display flashes, you are trying to make an unacceptable entry, or the value
on the display is at its range limit. The display may also show “KEYERR” (Key error).
6
Enter Value
or Selection
FUNCTION
or
SET UP
This key selects another function prompt.
This key selects another set up group.
NOTE: Pressing either key will cause the previously selected value or selection to be
entered into memory.
7
Exit Set Up
mode
DISPLAY
Exits set up mode and returns actuator to the same state it was in immediately preceding
entry into the set up mode. Any changes you have made are stored in memory.
If you do not press any keys for 30 seconds, the display times out and reverts to the
mode and display shown prior to entering the set up mode.
Record your selections on the Configuration Record Sheet .
Configuration Record Sheet
Group
Prompt
Function
Prompt
Value or
Selection
Factory
Setting
INPUT
IN TYP From MSG
INP HI 100
INP LO 0.0
FILTYP LPAS
LPFILT 0.5
DIRECT CCW
DBAND 0.5
FSTYPH UP
FSVALH 100
FSTYPL DOWN
FSFVALL 0
CHAR LINR
CUSTOM EQUL
X1 VAL 5
X2 VAL 10
X3 VAL 15
X4 VAL 20
X5 VAL 25
X6 VAL 30
X7 VAL 35
X8 VAL 40
X9 VAL 45
X10 VAL 50
X11 VAL 55
X12 VAL 60
X12 VAL 65
Group
Prompt
Function
Prompt
Value or
Selection
Factory
Setting
INPUT
(CONT
)
X14 VAL 70
X15 VAL 75
X16 VAL 80
X17 VAL 85
X18 VAL 90
X19 VAL 95
X20 VAL 100
Y1 VAL 5
Y2 VAL 10
Y3 VAL 15
Y4 VAL 20
Y5 VAL 25
Y6 VAL 30
Y7 VAL 35
Y8 VAL 40
Y9 VAL 45
Y10 VAL 50
Y11 VAL 55
Y12 VAL 60
Y13 VAL 65
Y14 VAL 70
Y15 VAL 75
Y16 VAL 80
Y17 VAL 85
Y18 VAL 90
Y19 VAL 95
Y20 VAL 100