Filter
Top Products
Controls and operation
Bridged mono/stereo
switch
Set this switch to STEREO when you are
using both left and right
RCA
input
connections.
Set this switch to MONO when you are
using only the left (mono)
RCA
connec-
tor.
The TC304 has two controls, one for the
front channels and one for the rear
channels. Set these switches as described
above. depending on which input connec-
tors you are using.
Note:
For simulta-
neous bridged mono/stereo satellite
operation. set this switch to STEREO.
Controls on the
TC600
and
TC300
Input sensitivity
control
WARNING:
When adjusting and testing
the system for proper amplifier input
sensitivity control level, you may easily
reach amplifier output levels which can
damage speakers.
Do
not operate the
system at ltigl~ output le\vls nl/iett distortio~
is present.
Test the system for correct amplifier input
level setting by momentarily advancing and
reducing the head unit volume control to
successively higher levels as long
as
there
is
no
distortion
up to a maximum of
718
volume control rotation.
If
you hear
distortion (clipping) on a successive
increment, immediately turn down the head
unit volume control and do not operate the
unit above this level unless the amplifier
-
input sensitivity is changed as described in
the following sections.