Filter
Top Products
I
High-level (speaker-level)
Solder each pair of speaker leads from the
connections
head
unit
to a male RCA connector. Con-
If
your head unit has low-]evel (preamp-
nect the positive lead to the center pin of the
1)
connectors available. connect as
RCA connector, and the negative lead to the
:ribed
in the previous section. If only
outside shield of the connector. Then attach
ker wires are available, connect as
each RCA connector to the INPUT connec-
:ribed here.
tors on the TC Series amplifier. (See the
"Controls and operations" section for
information about adjusting input level.)
f
Detail: RCA pm conneclor
3
Solder positive
(+)
speakei
lead
1-
to center pin.
L
High-level (speaker-level)
connections
SPEAKEROUT
L
R
Speaker
wires
from head unit.
Note: only one channel
shown.
Speaker output
connections
The size and quality of the wire you use to
connect your speakers to your
TC
Series
amplifier can affect the sound quality of
your system. Since the lengths of speaker
leads
in
a car are relatively short, any
speaker wire of 18-gauge or larger should
perform satisfactorily. However, audiophile
speaker cables may offer better perform-
ance.
For information about connecting specific
speaker configurations, see the "Application
drawings" section of this manual.