Filter
Top Products
SKU 02575 For technical questions, please call 1-800-444-3353. Page 9
Align the two mounting holes in a Rear Spring Hanger (15R) with the two mounting
holes located in the rear section of the Left Side Rail (1L). Insert two 3/8” x 7/8”
Carriage Bolts (A) upward from the underside of the aligned mounting holes, and
secure the Rear Spring Hanger to the Left Side Rail with two Washers (C) and two
Nuts (B).
Align the two mounting holes in the remaining Rear Spring Hanger (15R) with the
two mounting holes located in the rear section of the Right Side Rail (1L). Insert two
3/8” x 7/8” Carriage Bolts (A) upward from the underside of the aligned mounting
holes, and secure the Rear Spring Hanger to the Right Side Rail with two Washers
(C) and two Nuts (B).
Align the mounting hole on the end of a Spring (18) with the mounting hole located
on the side of one of the pre-attached Front Spring Hangers (15F), and secure the
Spring to the Front Spring Hanger with one Bolt (N) and one Nut (B).
Insert the second Spring Bolt (N) underneath the curved edge at the rear of the
Spring (18) and through the mount hole of the Rear Spring Hanger (15R). Secure
with one Nut (E).
For the remaining Spring (18), Front Spring Hanger (15F), and Rear Spring Hanger
(15R), repeat Steps #5 and #6.
Align the center mounting hole of a Spring Plate (16) with the center mounting hole
of a pre-attached Spring (18), and secure the Spring Plate to the Spring with two
U Bolts and Nuts (U Bolts fit underneath the axles with threaded ends up). Repeat
this step on opposite side of Trailer.
Align the center mounting hole of the remaining Spring Plate (16) with the center
mounting hole of the remaining pre-attached Spring (18), and secure the Spring
Plate to the Spring with one Bolt (A), one Washer (C), and one Nut (B).
With assistance, position the pre-assembled Tire, Wheel, and Axle Assembly under
the mid-section of the pre-assembled Frame of the Trailer.
On the right side of the Trailer, insert two U-Bolts (17) upward, over the right end of
the Axle (19), and through the four mounting holes in the Spring Plate (16). Then,
secure the right end of the Axle to the Spring (18) by tightening four Washers (C)
and four Nuts (B) onto the two U-Bolts.
On the left side of the Trailer, insert the remaining two U-Bolts (17) upward, over the
left end of the Axle (19), and through the four mounting holes in the Spring Plate (16).
Then, secure the left end of the Axle to the Spring (18) by tightening four Washers
(C) and four Nuts (B) onto the two U-Bolts.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
REV 05/03