Filter
Top Products
SKU 02575 For technical questions, please call 1-800-444-3353. Page 11
BOTTOM VIEW
LEFT SIDE RAIL (1L)
LEFT TAIL LIGHT (25L)
RIGHT TAIL LIGHT (25R)
RIGHT SIDE RAIL (1R)
RIGHT CONNECTING RAIL (8)
LEFT CONNECTING RAIL (7)
WIRING
HARNESS
USE HEAVY GAUGE, NYLON,
TIE STRIPS (NOT INCLUDED) TO
ATTACH WIRING HARNESS TO
UNDERSIDE OF FRAME.
FIGURE B
Use heavy gauge, nylon, tie strips (not included) to attach the wiring harnesses of
the Left and Right Tail Lights (25L, 25R) to the underside of the Frame and Tongue
Assemblies. (See Figure B.)
To Attach the Trailer Beds:
Align the four mounting holes of a Trailer Bed (X) with the two mounting holes in
the Left Side Rail (1L) and two mounting holes in the Right Side Rail (1R). Secure
the Trailer Bed to the Left and Right Side Rails with four Bolts (A), four Washers
(C), and four Nuts (B).
Align the four mounting holes of the remaining Trailer Bed (X) with the two mount-
ing holes in the Left Side Rail (1L) and two mounting holes in the Right Side Rail
(1R). Secure the Trailer Bed to the Left and Right Side Rails with four Bolts (A),
four Washers (C), and four Nuts (B).
Insert three Bolts (A) between the two pre-assembled Trailer Beds (X) and through
the three mounting holes in the Cross Member (2). Make sure the heads of the
Bolts overlap the edges of each of the Trailer Beds. Then firmly tighten the Bolts
with four Washers (C) and four Nuts (B).
The A-Tongue Trailer is now completely assembled and ready for use.
3.
1.
2.
3.
4.
REV 03d; 05f