Filter
Top Products
ix
Introduction
Installing Batteries
INSTALLING THE BATTERIES
The Geko 301 operates on two AAA batteries (not included), installed in the back of the
unit. To install the batteries, remove the battery cover by inserting a coin (quarter) in the
bottom slot. Twist the coin to lift the cover up and pull away. Insert the batteries, observ-
ing proper polarity. Attach the battery cover by inserting the tab end into the back slot at
an angle, laying it fl at, and then pushing it forward until the clip catches. Alkaline batteries
should last as long as 9 hours. Rechargeable Alkaline, NiMH, NiCad or Lithium batteries
may be used, but cannot be charged while in the unit.
Battery
Compartment
NOTE: If you intend to store your Geko 301 for an extended period of time,
remove the batteries. Follow the battery manufacturer’s instructions for the
proper care and handling of the batteries.
)
Battery usage icon shows
an estimate of battery
life left. Four squares
with the battery outline
indicates a full battery.
Four squares alone
indicates the use of an
external power source.
External power and data
connector (under rubber tab)
190-00297-02_0A.indd ix 5/19/2003, 4:20:01 PM