Filter
Top Products
54 StreetPilot 7200/7500 Owner’s Manual
APPENDIX
Setting Up the 7500 Software for DR
From the Menu page, touch Settings > Navigation >
> Dead Reckoning Setup > Settings.
Odometer Wave Type—select Square Wave or Sine
Wave. Determine the proper setting by contacting the
vehicle manufacturer or by using an oscilloscope. Square
Wave is the most common type.
Reverse Light Polarity—select High or Low. Contact
the vehicle manufacturer for polarity or check with a
voltmeter. Set to High (most common) if a positive,
high voltage is detected when the reverse lights are
illuminated. Set to Low if no voltage or low voltage is
detected when the reverse lights are illuminated.
Custom POIs (Points of Interest)
Your StreetPilot 7200/7500 accepts custom POI
databases, available from various companies on the
Internet. Some custom POI databases contain alert
information for points such as safety cameras and
school zones. Your StreetPilot can notify you when you
approach one of these points.
After downloading your POI database, use the Garmin
POI Loader to install the POIs into your unit. The POI
Loader is available at www.garmin.com/products/sp7500
for the 7500 and www.garmin.com/products/sp7200 for
the 7200. Select Updates and Downloads. Refer to the
POI Loader Help file for more information; press F1 to
open the Help file.
CAUTION: Garmin is not responsible for the
consequences of using a custom POI database or
the accuracy of third-party data.
To view your custom POIs, touch
Where to? >
Extras > Custom POIs.
Deleting Custom POIs
To delete all of the custom POIs, go to the Menu page
and then touch Tools > My Data > Custom POIs >
Delete All.