Filter
Top Products
To flush mount the GPS 128:
The GPS 126/128 can be mounted flush with a flat
panel of .08-.52” thickness using the cam lobe feature
on its mounting bracket.
1. Cut a 4.15” W x 4.67” H hole in panel.
2. Place GPS 128 into hole from the front until its flange
rests against the mounting surface.
3. From the back side of the panel, loosely attach the
bracket such that the slot in the ratchet area points
away from the mounting panel.
4. Rotate the bracket downward until the panel
is pinched tightly between the units flange
and bracket lobe.
5. Tighten knobs and connect the power/data
and antenna cables. Note: If the panel is too thick to
allow use of the supplied knobs, use two M6 screws to
secure the bracket.
Installation
Appendix b
56
126/128 Manual (new) 6/15/98 9:52 AM Page 56