Filter
Top Products
52
Initializing for First-Time Use
The GPS 126/128 typically acquires a position so
fast that initialization is automatic. However, initializa-
tion will be necessary for the following:
• After memory loss
• When the receiver has been moved more than
500 miles with the power off
Additionally, it may be necessary to initialize the
unit the first time you use it, if it does not acquire a fix
in a few minutes.
The receiver is shipped from the factory in
AutoLocate™ mode, which enables the GPS 126/128 to
determine its location anywhere in the world. To speed
up the initialization process, we recommend using the
graphic initialization described below.
To turn the GPS 126/128 on:
1. Press and hold
P
until the receiver turns on.
The welcome page will be displayed while the unit
conducts a self test.
Once testing is complete, the welcome page will be
replaced by the Satellite Page, with the EZinit prompt
ready for you to select one of two initialization
methods:
•Select Country––allows you to initialize the
receiver by selecting your present position from a
list of countries in the GPS 126/128’s internal data-
base. This may speed up the initialization process.
•Autolocate
TM
––allows the GPS 126/128 to initial-
ize itself and calculate a position fix without know-
ing your present position. This usually provides a
position fix in 3-5 minutes.
If the EZinit prompt has not automatically
appeared on the Satellite Page:
1. Press the
F
key.
Note: If the EZinit prompt ever appears after you
have initialized the receiver (due to the antennas view
of satellites being obstructed by trees, etc.), highlight
the ‘no re-init’ selection with the arrow keypad and
press
F
.
Initialization
APPENDIX A
Welcome Page
The EZinit prompt will
automatically appear if
the receiver needs to be
initialized. The prompt
may also appear during
normal use if the antenna
is shaded.
126/128 Manual (new) 6/15/98 9:51 AM Page 52