Filter
Top Products
53
To initialize the receiver:
1. If the ‘country’ option is not highlighted, press the
D
key repeatedly to move the field highlight to the
‘COUNTRY’ option.
2. Press the
F
key.
3. Use the
D
key to scroll through the list options until
the country of your present position appears.
4. Use the
U
key to highlight the country/state/region
you’re in. If the country you’re in is not listed, select
another country within 500 miles of your present
position.
5. Press
F
to finish.
The GPS 126/128 will now begin searching for the
appropriate satellites for your location and should
acquire a position within 3-5 minutes. You can verify
that you have acquired a position by watching the
Satellite Page transition to the Position Page (provided
you haven’t pressed any other buttons) or by looking
for a ‘2D NAV’ or ‘3D NAV’ status at the top-left corner
of the Satellite Page.
Initialization Troubleshooting
If you have trouble initializing the receiver or
acquiring a position, check the following:
• Does the unit have a clear view of the sky?
If there are large buildings or mountains nearby, or
if there is heavy tree cover, the receiver may not be
receiving enough satellite signals to calculate a
position.
• Have you selected the right country/state/region
from the EZinit list?
Check for the correct approximate lat/lon on the
Position Page, or reselect the appropriate country
from the list to restart the initialization.
• Have you moved more than 500 miles from the
last calculated position with the receiver off?
Reinitialize the receiver, selecting the country/state/
region of your new location from the EZinit list.
Use the arrow keypad to
highlight the country,
region, or state of your
present position from the
list and press ENTER. If
the country is not listed,
select the closest country
instead.
APPENDIX A
Initialization
126/128 Manual (new) 6/15/98 9:51 AM Page 53