Filter
Top Products
12 GMR 600/1200 Series Installation Instructions
The radar radome transmits electromagnetic energy. Ensure that the radome has
been installed according to the recommendations given in this guide, and that
all personnel are clear of the radome before switching to transmit mode.
When navigating, carefully compare information displayed on the unit to all
available navigation sources, including information from visual sightings,
and maps. For safety, always resolve any discrepancies or questions before
continuing navigation.
•
•
Use the electronic chart in the unit only to facilitate, not to replace, the use
of authorized government charts. Ofcial government charts and notices to
mariners contain all information needed to navigate safely.
Use this unit only as a navigational aid. Do not attempt to use the unit for any
purpose requiring precise measurement of direction, distance, location, or
topography.
•
•
Warnings
This product, its packaging, and its components contain chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. This
Notice is provided in accordance with California’s Proposition 65. See www.garmin.com/prop65 for more information.
Do not cut the fuse holder from the red wire. The fuse holder must remain in place for the Garmin radar to function correctly. Removing the inline fuse holder
may damage your boat's circuitry.
Check with local authorities for any operational restrictions or licensing requirements that may apply while using this device.
Do not use the GMR 600/1200 series radar on inland Belgium waters because the radars exceed authorized Belgian power transmission levels for inland waters.
FCC Compliance
The GMR 600/1200 series radar complies with Part 80 of the FCC rules. It has received a grant of equipment authorization, issued under the
authority of the FCC.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Industry Canada Compliance
The GMR 600/1200 series radar complies with Industry Canada Standard RSS-138.
Declaration of Conformity (DoC)
Hereby, Garmin, declares that the GMR 600/1200 series radar is in compliance with the essential requirements and other relevant provisions of
Directive 1999/5/EC.
To view the full Declaration of Conformity, see the Garmin Web site for your Garmin product: www.garmin.com.
•
•
•
•