Garmin 10 GPS Receiver User Manual


 
2 Garmin Mobile
10 set up and go!
➊
Install the Battery
Locate the black or gray lithium-ion battery that
came in the product box.
With your thumbnail, slide the battery cover release
tab toward the end of the GPS 10x.
Pull the battery cover off.
Locate the metal contacts on the end of the lithium-
ion battery. Insert the battery so the metal contacts
on the battery match up with the metal contacts
inside the battery compartment. Press the battery
down into place.
Replace the battery cover by inserting the tabs into
the notches. Press the battery cover closed; the
release tab locks the cover in place.
1.
2.
3.
4.
5.
Replacement Battery
If you need to replace the battery, use a Garmin 3.7 Volt
lithium-ion battery pack (010-10840-00). Purchase a
replacement battery at http://my.garmin.com/shop. You
can also use a compatible cell phone battery, such as a
Nokia BL-5C.
➋
Charge the GPS 10x Receiver
Plug the small end of the power cable into the mini-
USB connector on the end of the GPS 10x.
Plug the other end of the power cable into an
available power outlet in your vehicle.
You can use the GPS 10x receiver while you are
charging it. It takes about four hours to charge the
battery. A fully charged battery lasts about 22 hours.
1.
2.
Release
tab
Battery
cover
Lithium-ion
battery