Filter
Top Products
6. INITIAL SETTINGS
21
Setting DATA 4 to “COM.” (general data)
Waypoints and Routes data can be received from a personal computer, through the DATA
4 port.
1) Press MENU ESC, 9 and 5.
2) Press
S or T to select DATA4. Level.
3) Press
W or X to select level of personal computer; RS232C or RS422.
4) Press the NU/CU ENT key.
5) Press
X to select Com.
6) Press
T to select To Next Page. The DATA 4 I/O SETUP <Com.> menu appears.
To Previous Page
Baud Rate 9600 bps
L WPT
Command Stop Start
Save Data WPT/RTE
Command Stop Start
DATA 4 I/O SETUP <Com.> 2/2
MENU : Escape
ENT : Enter
: Select
Load Data
WPT/RTE
DATA 4 I/O SETUP <Com.> menu
7) Press
S or T to select Baud Rate.
8) Press
W or X to select baud rate; 4800bps, 9600bps or 19200bps.
9) Press the NU/CU ENT key.
10) Press
W or X to select WPT/RTE.
11) Press
T to select Command. Stop, on the same line as Command, appears in reverse
video.
12) Press
X to select Start. The message shown in figure below appears.
Loading erases current data
and stops Route navigation
Are you sure to load?
ENT: Yes MENU: No
13) Press the NU/CU ENT key. The message shown in below appears while data is being
loaded.
Now loading
Waypoint/Route data !
MENU: Stop