Furuno 1715 Radar Detector User Manual


 
3. INSTALLATION
27
1. Turn on the power while pressing and
holding down the [MENU/ESC] key.
Continue pressing the [MENU/ESC] key
until the Installation menu appears.
INSTALLATION MENU
SIMULATION OFF
TEST...
LCD PATTERN...
MEMORY CLEAR
NMEA PORT : IN/OUT
NMEA OUTPUT : OFF
GPS WASS : OFF
GO TO RADAR SETUP...
Installation menu
2. Press to choose GOTO RADAR
SETUP.
3. Press . Power is then reset.
4. Wait one minute, press the
[POWER/BRILL] key followed by the
[MODE] key to transmit.
5. Press the [MENU/ESC] key to show the
User menu.
6. Press to show the Radar Setup menu.
RADAR SETUP
HEADING ADJUST
TIMING ADJUST
SET ON TIME : 000000h
SET TX TIME : 000000h
[MENU/ESC]: Exit.
Radar setup menu
7. HEADING ADJUST is selected; press
to show the options window.
RADAR SETUP
HEADING ADJUST
TIMING ADJUST
SET ON TIME : 000000h
SET TX TIME : 000000h
[MENU/ESC]: Exit.
: YES
: NO
Radar setup menu (heading adjust)
8. Press to choose YES, and the display
now looks as below.
HEADING LINE ADJUSTMENT BY
AND KEYS.
THEN PUSH MODE KEY TO SET.
Heading Line
Message
Heading adjustment display
9. Visually identify a suitable target (for
example, ship or buoy) at a range
between 0.125 to 0.25 miles.
10. Point your boat’s bow directly toward the
target selected at step 9.
11. Locate the target selected at step 9 on
the display and choose a range which
places it in the outer half of the picture.
12. Press or to bisect the target with the
heading line.
Heading Line
Target
Heading adjustment display
13. Press the [MODE] key.
14. Press the [MENU/ESC] key to return to
the Installation menu.
15. Move the boat towards a small buoy and
confirm that the buoy shows up dead
ahead on the radar when it is visually
dead ahead.