Filter
Top Products
10
00989pr-1056
ASSEMBLY
14
• Insert two #8 x 2" (5 cm) screws into the upper holes
in the brush guard and tighten.
• Fit both hand grips on the ends of the handlebar.
Hint: If it is difficult to slide a hand grip onto the
handlebar, moisten the inside of the grip with water.
Hand Grip
Hand Grip
BACK VIEW
15
Seat
Drive Buttons
• Fit the tab at the front of the seat into the slot below
the drive buttons
A
.
• “Snap” the tab at the back of the seat into the slot
near the rear of the vehicle
B
.
Decorative Labels
• Please refer to the Decoration instructions included
on a separate sheet to apply decorative labels to
your product.
•
Before applying the labels, wipe the surface of the vehicle
with a clean, dry cloth to remove any dust or oils.
• Place the labels exactly as shown in the illustrations.
For best results, avoid repositioning a label once it has
been applied to the vehicle.
• After applying a label, rub the label firmly with a clean,
dry cloth to make sure the label is adhered to your
vehicle. Start at the center of a label, and smooth
towards the outer edges to remove air bubbles.
A
B
17
• Locate the opening below the drive buttons.
• Reach into the opening and pull the high speed
connector out through the opening.
•
Refer to page 13 for information on high speed operation.
Connector
Drive Buttons
16