Filter
Top Products
9
K3034pr-0921
5
BOTTOM VIEW
ASSEMBLY
• Fit the steering column cap onto the end of the steering column
A
.
• Insert a #8 x
3
/
4
" screw through the large opening in the steering
column cap and the hole in the steering column
B
.
Tighten the screw.
Hint: You may need to adjust the steering column cap to properly fit
the screw.
• Turn the vehicle upright.
Steering Column Cap
B
A
7
UNLOCKED
6
LOCKED
Lock Fastener
Lock Fastener
Note: If you have already charged your Power Wheels
®
6 Volt
(4.0 Amp/Hr.) battery for at least 18 hours, you may want to
re-install it into the battery compartment before assembling
the seat to your vehicle. Please refer to the Battery Installation
section beginning on page 11 for instructions.
• Insert the tab on the front of the seat into the slot in the vehicle.
• Use a slotted screwdriver to rotate the lock fastener
1
/4 turn to
the locked position .
• To unlock the lock fastener, use a slotted screwdriver to rotate
the lock fastener
1
/4 turn to the unlocked position .
IMPORTANT! Remember to keep the lock fastener locked at all
times to prevent children from accessing the vehicle battery.
Lock Fastener
Seat
Tab
• Fit the wrench into the hole in the top side of the vehicle,
near the seating area.
Wrench
End of Steering
Column
Steering Linkage
4
• Fit the end of the steering column through the hole in the
steering linkage.