Filter
Top Products
11
K3034pr-0921
2
BATTERY INSTALLATION
1
3
Motor Connector
Battery Connector
• To unlock the lock fastener, use a slotted screwdriver to rotate
the lock fastener
1
/4 turn to the unlocked position .
• Lift the seat to remove it from the vehicle.
Lock Fastener
Lock Fastener
Lock Fastener
Seat
LOCKED UNLOCKED
IMPORTANT! Use only a Power Wheels
®
6 Volt (4.0 Amp/Hr.)
lead-acid rechargeable battery. Use of any other battery will
damage your vehicle. Make sure that you charge the battery
for at least 18 hours using the enclosed Power Wheels
®
6 Volt (4.0 Amp/Hr.) charger before operating your vehicle for
the first time. Charge the battery for at least 14 hours after
each use of the vehicle. Never charge the battery longer than
30 hours. Failure to follow these instructions may damage
your battery and will void your warranty.
Battery Retainer
• Loosen and remove the screw in the battery retainer.
Remove the battery retainer.
• Place the Power Wheels
®
6 Volt (4.0 Amp/Hr.) battery upright
in the battery compartment. Make sure the battery connector
extends toward the rear of the vehicle.
• Fit one end of the battery retainer into the hole in the vehicle.
• Insert the #8-18 x
7
/
8
" screw through the end of the battery
retainer and into the vehicle. Tighten the screw.
• Fit the battery connector into the motor connector.
Hint: If the battery connector will not plug into the motor
connector, turn it over and try again! Do not force the battery
connector into the motor connector.
• Re-assemble the seat to the vehicle.
IMPORTANT! Always remember to keep the lock fastener locked
at all times to prevent children from accessing the battery.