Filter
Top Products
7
K3034pr-0921
1
2
BATTERY CHARGING
Battery Retainer
• Plug the charger into a standard wall outlet.
Notes:
– If power flow to the wall outlet is controlled by a switch,
make sure the switch is ON.
– Use the charger only in a wall outlet. Do not plug the charger
into a ceiling outlet.
• Before first time use, charge the battery for at least 18 hours.
Never charge the battery longer than 30 hours.
• Recharge the battery after each use of your vehicle for at least
14 hours. Do not charge the battery longer than 30 hours.
• Once the battery is charged, disconnect the charger connector
from the battery connector. Unplug the charger from the wall
outlet. The battery is now ready to be installed in your vehicle.
Please see “Battery Installation” on page 11 for detailed
instructions on installing your battery. If your battery is already
installed in your vehicle, simply re-connect the battery connector
and motor connector and replace the battery retainer.
IMPORTANT! The battery must be removed from your vehicle
for the initial charge in order to complete assembly. You do not
need to remove the battery from the vehicle to recharge it.
• Using a Phillips screwdriver, loosen the screw in the battery
retainer. Remove the battery retainer from the vehicle.
• Remove the Power Wheels
®
6 Volt (4.0 Amp/Hr.) battery from
the battery compartment.
• Discard any cardboard that may have been used to protect the
battery during shipping.
• Fit the charger connector and the battery connector together.
Battery
Connector
Charger
Connector