Filter
Top Products
19
Assembly
•Position the gas cap so that its tether points down.
• Snap the gas cap into the hole under the right taillight.
Gas
Cap
Tether
40
Taillight
Lens
Taillight
Housing
Rear Bumper Light Plate
•Lift the rear of the vehicle.
• Align the holes in the rear bumper tabs with the screw
pegs on the underside of the vehicle.
•Insert two #8 x 1" screws through the bumper tabs and
into the vehicle.
• Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
•Lower the rear of the vehicle.
Bumper Tabs
Rear
Bumper
• Using safety scissors, remove the taillight lenses and the
taillight housings from the plastic connectors. Dispose of
the plastic connectors.
•Face the rear of the vehicle.
• Fit a taillight lens inside a taillight housing.
•Position the taillight housing with lens against a rear
bumper light plate with the screw holes aligned.
•Insert two #8 x 1" screws through the taillight lens, rear
bumper light plate housing and into the vehicle body.
• Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
•Repeat this procedure to attach the other taillight.
38
39
• Using safety scissors, cut and remove the strap holding the
shovel to the hood. Discard the strap.
• Replace the shovel back into the holder on the hood.
Strap
Shovel
41