Filter
Top Products
18
Assembly
•Turn the vehicle on its side.
•Insert two #10 x
1
/
2
"
screws into the holes in the
underside of each rear wheel well, through the vehicle
body and into the ends of the sport bar.
• Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
Rear of
Vehicle
36
37
Bottom View
•Fit the sport bar assembly into the holes in the
vehicle body.
• Push down firmly on a sport bar support while pulling
up on the side fender to fit the sport bar into the
vehicle body.
• Repeat this procedure on the other side of the
vehicle body.
Side
Fender
PULL
HERE
PUSH
HERE
35
Rear Bumper
Support
Tabs
•Turn the vehicle upright.
•Face the rear of the vehicle.
•Fit the lower rail on the rear bumper over the rear
bumper supports.
•Gently bend the tabs at the bottom of the rear bumper
under the vehicle.
Rear Bumper
Lower Rail
• Fit the light covers to the lights on the sport bar, as shown.
•Insert a #10 x
1
/
2
"
screw through the light cover and into
the light. Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
Light
Cover
Light
Cover
Lights
34