Filter
Top Products
12
Assembly
2
1
Battery
Compartment
Dash
•Position the dash on the vehicle body.
•Make sure the motor connector is through the groove in
the dash.
• Insert a #10 x
1
/2" screw through each of the two corner
dash tabs nearest to the passenger compartment .
• Insert a #10 x 1" screw through the two dash tabs
nearest to the battery compartment .
• Insert a #10 x 1" screw into the hole in the center of the
dash, near the battery retainer clip .
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
Battery Clamp
Motor
Connector
12
Light Wire
Wire Clip
• Fit the light wire into the wire clip.
10
Light Wire
Connector
Radio Wire
Connector
• Plug the light wire connector into the sound unit wire
connector. Push firmly to make sure the connectors are
completely joined.
11
Dash
Key Assembly
• Insert and “snap” the key assembly into the opening in
the dash, as shown.
13