Filter
Top Products
Do Not Omit Any Steps
Assembly
3
F
10
2
1
• Snap the shift lever, key assembly and knobs into the
dashboard, as shown.
Shift
Lever
Key Assembly
Knobs
Dashboard
• Insert the end of the microphone cord through the small
round hole in the dashboard.
• Bend the the plastic tip at the end of the microphone
cord so that it forms a “T” behind the dashboard.
• Pull gently on the microphone cord to make sure it is
secure in the dashboard.
• Fit the tab on the back of the microphone into the oval
hole in the dashboard to hang it on the dash.
Microphone
“T” End
Plastic Tip
Round Hole
Oval Hole
• Slide the front wheels off the front axles.
• Fit the dashboard on the vehicle body.
• Insert four #8 x
3
/4" screws through the holes in the dash-
board and into the vehicle body.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
Dashboard
Vehicle
Body
Front Axle
Front Wheel
4