Filter
Top Products
23
Radio Knob
• Snap the radio knobs into the holes in the dash.
15
21
• Bend the plastic tip at the end of the microphone cord so
that it forms a "T".
• Insert the plastic tip through the hole in the handlebar
housing, where the two halves meet.
• Pull lightly on the microphone cord to make sure it is
secure in the dash.
• Fit the tab on the back of the microphone into the hole in
the center of the dash to hook it to the dash.
• Snap the key assembly into the large hole in the dash.
Microphone
Key Assembly
• Fit a hand grip onto each end of the handlebar. If it is dif-
ficult to slide the hand grips onto the handlebar, moisten
the hand grips with warm water first.
Handlebar
Hand Grip
22
Assembly
20
• Fit the headlight rim against the opening at the front
of the handlebar housing, with the headlight guard
facing out.
• Insert four
1
/2" screws (black) through the holes in the
headlight rim and tighten the screws with a Phillips
screwdriver. Do not over-tighten.
Headlight
Rim
Headlight
Guard