Filter
Top Products
Assembly
Do Not Omit Any Steps
3
F
10
2
1
• Fit the cover plate over the opening in the front of the
vehicle body.
• Insert two
1
/
2" screws (silver) through the cover plate and
into the vehicle body.
Mudflap
Rear of
Vehicle Body
Rear Fender
(Underside)
Cover Plate
Vehicle
Body
• Tip up the back end of the vehicle.
• Using safety scissors, remove the mudflaps from the
plastic connector. Dispose of the plastic connector.
• Align the holes in a mudflap with the screwpegs under
one of the rear fenders. Make sure the textured side of
the mudflap faces toward the seat.
• Insert four
1
/2" screws (silver) through the mudflap and
into the screwpegs.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
• Repeat this procedure to assemble the other mudflap to
the other rear fender.
• Fit a hubcap on the rear axle and slide it into the center
of the rear wheel.
• Position the vehicle body upside down. Make sure that
the tabs on the gearboxes rest against the rear axle
support bars so the gearboxes and motors do not
hang down.
• Slide two large washers onto one of the rear axles.
• Slide a rear wheel, driver side first, onto the rear axle.
• Fit the teeth on the gearbox into the notches in the driver.
Large
Washers
Tabs
Rear Axle
Support Bar
Rear Wheel
Rear Axle
Gearbox
Driver
Teeth
Rear Axle
Hubcap
4