Filter
Top Products
• Fit a hubcap on the front axle and slide it into the center
of the front wheel.
• Slide a hex bushing onto the front axle. The ring side of
the hex bushing should face out.
• Press firmly to fit all but the ring on the end of the hex
bushing into the front wheel.
Front Axle
Hex Bushing
Ring Side
Front Hubcap
Front Axle
10
9
• Fit a cap nut on the end of the front axle.
• Tap the cap nut with a hammer to secure it on the end of
the front axle.
• Pull on the wheel to make sure the cap nut is securely
fastened.
• Repeat this procedure to assemble the other front wheel
to the other front axle.
• Set the vehicle body aside.
Cap Nut
• Position the handlebar so that the side with the three
holes and circular indentation faces up.
• Fit the neck against the bottom of the handlebar, with
the holes in the handlebar and neck aligned.
• Insert a 1
1
/2" screw down through each of the two outer
holes in the handlebar and then through the neck.
• Fit a lock nut on the end of each screw.
•Using pliers to steady the lock nuts, tighten each screw
with a Phillips screwdriver. Do not over-tighten.
12
11
12
Holes
Lock Nut
Handlebar
Circular
Indentation
Neck
Assembly