Filter
Top Products
Rear Bumper
Support
Tabs
• Face the rear of the vehicle.
• Fit the lower rail on the rear bumper over the rear
bumper support.
• Gently bend the tabs at the bottom of the rear bumper
under the vehicle.
Rear Bumper
Lower Rail
43
Assembly
22
46
Taillight
Lens
Taillight Housing
Rear Bumper Light Plate
45
• Lift the rear of the vehicle.
• Align the holes in the bumper tabs with the screw pegs on
the underside of the vehicle body.
• Insert two #8 x 1" screws through the bumper tabs and
into the vehicle body.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
• Lower the rear of the vehicle.
Gas Cap
Tether
Bumper Tabs
Bumper
• Position the gas cap so that its tether points down.
• Snap the gas cap into the opening on the rear bumper.
• Using safety scissors, remove the taillight lenses and
the taillight housings from the plastic connectors.
Dispose of the plastic connectors.
• Face the rear of the vehicle.
• Fit a taillight lens inside a taillight housing.
• Position the taillight housing with lens against a rear
bumper light plate with the screw holes aligned.
• Insert two #8 x 1" screws through the taillight lens, rear
bumper light plate housing and into the vehicle body.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
• Repeat this procedure to attach the other taillight.
44