Filter
Top Products
• Fit a spacer tube between the grille and the
back of the brushguard, as shown.
• Insert a #8 x 4" screw through the
brushguard and spacer tube and into the
hole in the grille.
• Tighten the screw with a Phillips screwdriver.
Do not over-tighten.
• Repeat this procedure on the other side of
the grille.
Spacer Tube
15
Headlight
Lens
Wide Notch
Wide Tab
Lens
Guard
12
• Fit the wide notch in the side of a headlight lens under
the wide tab on a lens guard.
• Press firmly on the inside of the headlight lens to snap it
into the lens guard.
• Repeat this procedure to assemble the other headlight
lens to the remaining lens guard.
Assembly
14
14
• Fit the lens tabs on the back of a lens assembly into the
headlight slots in the grille.
• Press firmly to snap the lens assembly into the grille.
• Repeat this procedure to snap the other lens assembly
into the grille.
Grille
Tab
Slot
13
Brushguard
Bumper
• Fit and hold the brushguard against the front bumper.
• Insert two #10 x 1" screws through the front of the
brushguard and into the bumper.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.