Filter
Top Products
12
• Slide the rear wheel spacer onto the rear axle.
• Slide the other rear wheel driver, barrel side first, onto
the rear axle.
• Slide the other rear wheel, rib side first, onto the rear axle.
Fit the grooves on the rear wheel driver to the ribs on the
rear wheel.
• Slide a hex bushing, barrel side first, onto the rear axle.
• Fit a .437 cap nut onto the rear axle.
• Tap the cap nut with a hammer to secure it on the
rear axle.
Hint: You may want the help of another adult to support the
vehicle body while you tap the cap nut with
the hammer.
• Pull on the .437 cap nut to make sure the rear wheel
assembly is secure.
5
• Lift the pretend buckles on the trunk and open the trunk.
• Fit the slots on the bottom of the trunk onto the tabs
on the back end of the vehicle body.
Assembly
Rear
Wheel
Driver
.437 Cap Nut
Rear Wheel
Spacer
Rear Axle
Rear
Wheel
Rib
Hex
Bushing
Trunk
Trunk
Tab
Tab
Seat
Tabs
Slots
• Align the holes in the trunk with the holes in the
vehicle body.
• Insert two #8 x
3
/
4
" screws through the holes in the trunk
and into the vehicle body.
• Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
6
Back View
Back View
Back View
• Insert the tabs on the front of the seat into the slots
inside the vehicle body.
• Lower the back of the seat.
7
4
Hex Bushing
Barrel Side
Holes
Top View