Filter
Top Products
18
Assembly
• Fit a .354 cap nut on the end of a steering column.
• Tap the cap nut with a hammer until the cap nut is
secure on the steering column.
• Pull on the cap nut to be sure it is secure on the
steering column.
.354 Cap Nut
End of
Steering
Column
• Fit the curved end of
the steering column
through the hole in the
steering linkage.
See
Inset
Curved
End of
Steering
Column
Steering
Linkage
Steering
Linkage
Hole
.354"
Curved
End of
Steering
Column
.354 Cap Nut
30
31
• Place the steering wheel top face down on a flat surface.
• Fit the steering wheel bottom to the steering wheel top.
• Insert four #8 x
3
/
4
" screws through the steering wheel
bottom and into the steering wheel top. Tighten the
screws with a Phillips screwdriver. Do not over-tighten.
Steering
Wheel
Bottom
Steering
Wheel Top
32
Bottom View
Bottom View
73520 Dodge Ram 6/27/01 2:57 PM Page 18