Fiat 1.4 Automobile User Manual


 
24 Rear view mirrors
1
Interior
1 The mirror may be removed after extracting
the fixing screws. The mirror is designed to
break off if struck.
Exterior
2 The mirror is remotely controlled. To
remove the mirror, peel back the rubber cover
from the control knob (photo).
3 Unscrew the ring nut using a C-spanner or
similar (photo).
4 Withdraw the mirror from its mounting
hole, the triangular trim plate will come
with it. Refitting is a reversal of removal
(photo).
25 Grab handles
1
1 These are located above the door openings
and can be removed if the end covers are
prised back on their hinges to expose the
fixing screws (photo).
26 Rear bumpers -
removal and refitting
1
1 Refer to Chapter 9 and withdraw the
number plate lamp. Disconnect the leads.
2 Open the tailgate and three bumper fixing
bolts from the top edge.
3 Working under the car, remove the two side
and the three lower edge fixing bolts.
4 Remove the bumper from the car.
5 Refitting is a reversal of removal.
27 Roof rack
1
1 As the car is not fitted with conventional
type rain water gutters, the Fiat roof rack
should be used which incorporates clamps
which engage under the door arches. The
doors are then closed on them.
2 On three-door models, the rear clamps fit
into recesses provided just above the rear
side window weatherseals.
Bodywork 12•11
24.4 Withdrawing exterior mirror and trim
plate
25.1 Grab handle screw
24.3 Mirror ring nut and C-spanner24.2 Exterior mirror control knob
Fig. 12.23 Sunroof control handle (A)
(Sec 28)
Fig. 12.22 Roof rack clamp locations
(Sec 27)
Fig. 12.21 Rear bumper (Sec 26)
12