Filter
Top Products
Page 4
When the “Edit” menus have been
selected, press the “Mode” button to
return to “Normal” mode.
Press the “Down” or “Up” buttons to cycle
between the available “Edit” functions.
Press and hold the “Down” and “Up”
buttons for two (2) seconds to select an
“Edit” function to change.
Within each “Edit” function, the “Down”
or “Up” buttons select settings or sub-
functions. Follow the instructions in the
“Edit” mode section of this manual to
save the new settings after you select
and adjust them.
Normal Mode
When the MG2000 is turned on, the unit
will beep once and then enter the “Self
Test” mode. The screen will display “The
Self Test Mode Is In Operation” for 10
seconds The horn will sound three times
and the warning lights and backlights
will flash. When this is complete, the
user selected “Default” screen will
appear. The information below applies
to the MG2000 as received with no user
changes to the screen selections.
Contrast and Lighting
In the “Normal” operating mode
the instrument display contrast and
display mode can be adjusted by
pressing the “Down” and “Up” buttons.
With the display in “positive” mode, black
on white, pressing the “Down” button
decreases contrast.
Pressing the “Up” button increases
contrast.
Continuing to press the “Up” button
causes the display to reverse to the
“negative” mode, white on black. Contrast
in this mode is controlled the same way.
To return to “positive” mode continue to
press the “Down” button until the display
reverses.
To adjust the lighting level intensity of
all instruments in the system, press and
hold both the “Up” and “Down” buttons
for 2 seconds. The lighting intensity of
all instruments can now be adjusted
by pressing either the “Up” or “Down”
buttons.
Return to “Normal” mode by pressing
and holding both the “Up” and “Down”
buttons. The setting of the last lighting
level selected is saved and the next time
the instrument is turned on that level is
used.