Filter
Top Products
RELATED PUBLICATIONS LBI-38988
Rev. B 9
RELATED PUBLICATIONS
It may be necessary to consult one or more of the
following documents during the installation process. These
manuals will also provide additional guidance if you
encounter technical difficulties during the configuration
process.
LBI-38430 - MASTR IIe Control Shelf Maintenance
Manual.
LBI-38636 - MASTR III Base Station Installation
Manual.
LBI-38822 - Turbo Board (GETC-1e) Maintenance
Manual.
LBI-38894 - GETC Trunking Card Maintenance Manual.
LBI-38896 - EDACS Site Downlink and CEC/IMC
Uplink Configuration Manual.
LBI-38985 - EDACS Site Controller Maintenance
Manual.
LBI-38987 - EDACS SCAT & SCAT Downlink
Configuration Manual.
LBI-39149 - EDACS Compact Vertical Voter
Maintenance Manual.
LBI-39186 - EDACS Simulcast Control Point
Maintenance Manual.
LBI-39187 - EDACS Voted Digital Interconnect
Configuration Manual.
SRN-1010 - Software Release Notes for GETC Turbo
Board Software, 344A4414G1 only.
SRN-1024 - Software Release Notes for GETC 900 MHz
Software, 19A705595G8.
SRN-1060 - Software Release Notes for GETC-1e
Software, 349A9607G1 (or later).
SRN-1062 - Software Release Notes for Turbo Board
with GETC-1e Software, 344A4414G2 (or
later).
TQ-3357 - GETC Shelf Programming Manual
SOFTWARE COMPATIBILITY
GETC EPROM and TURBO BOARD
SOFTWARE COMPATIBILITY
The following software is required for GETCs used in
the Station configurations:
Table 1 - GETC EPROM and Turbo Software
Compatibility
GETC LOGIC BOARD
EPROM, U2
TURBO BOARD
SOFTWARE
349A9607G5
344A4414G5
349A9607G4
344A4414G4 (or later)
349A9607G2
344A4414G3 (or later)
349A9607G1 (800 MHz
only)
344A4414G2 (or later)
19A705595G8 (900 MHz
only)
344A4414G1
344A3835G2 (SCAT only)
344A4414G2
CAUTION
To ensure system compatibility, all repeaters and
Satellite Receivers should have the same firmware
versions installed. Also, for proper Voted or
Simulcast operation, Test Unit Software
19A705272 Group 6 is required. Failure to
observe these precautions could result in less than
acceptable system operation.
NOTE
Software used in the GETC is subject to changes
resulting from improvements or enhancements.
Refer to release notes SRN1060, SRN1061 and
SRN1062 for compatibility of GETC1e with other
EDACS platforms. Software Release Notes take
precedence over this manual.
EDACS COMPONENT SOFTWARE
COMPATIBILITY
The data presented in Table 2 represents the minimum
EDACS component software versions required to support
the features indicated.
NOTE
If a system has Group 5 Link software and Group
11 IMC software, then the Site Controller must
use Group 6 (or later) software.
NOTE
CAUTION
NOTE