Filter
Top Products
www.edelbrock.com
Page 10 of 17
Setting +12V Timer Output Hold ON/OFF
Enter the Options Menu, press and release the FUNCTION switch until the message "+12V Timer Output Hold"
appears on the display.
Press and release the ENTER switch to turn this feature ON or OFF. After pressing the ENTER switch, the
display will show the new state of the selected option. Refer to "Exiting the Options Menu" to return to the Main Menu.
When this option is OFF (Factory Default) the +12V timer output will turn OFF each time the activation signal
is removed.
Enabling Quick Data Access
Enter the options menu, press and release the FUNCTION switch until the message "Quick Data Access"
appears on the display.
Press and release the ENTER switch to turn this feature ON or OFF. After pressing the ENTER switch, the
display will show the new state of the selected option. Refer to "Exiting the Options Menu" to return to the Main
Menu.
auto
When this option is ON (Factory default is OFF), the data will appear before the text in the Main Menu. Those
familiar with the controller can access or check the current setup much more quickly.
Setting the RESET Timeout Period
Enter the Options Menu, press and release the FUNCTION switch until the message "Timeout in Seconds"
appears on the display.
Press and release the ENTER switch to increase the timeout period in 10 second increments. If the timeout
period is more than 180 seconds, the controller will default back to 20 seconds. Refer to "Exiting the Options Menu"
to return to the Main Menu.
NOTE - If the timeout period is 100 seconds or more the Run Data Time will be recorded in .01 second resolution.
Exiting the Options Menu
Press and release the FUNCTION switch until the message "Exit Options Menu" appears on the display.
Press and release the ENTER switch to return to the Main Menu.
auto
Press and release the FUNCTION switch to return to the top of the options menu.
©2008 Edelbrock Corporation
Catalog #71900
Brochure #63-0473
Rev. 08/08 - AJ/mc