Eclipse - Fujitsu Ten AVN5435 GPS Receiver User Manual


 
144
For reference
1. Information you should know
If one of these messages appears
If any of the following messages are displayed, check the unit while referring to the Cause
and Remedy columns.
Messages Cause Corrective action
Check GPS antenna
The GPS antenna is not connected
properly.
Connect the GPS antenna
properly.
Check speed pulse
The device is not properly
connected to the vehicle speed
sensor.
Connect the vehicle speed sensor
properly.
No DVD. Please insert map DVD. The map disk is not inserted. Insert the map disk.
Unable to read data. Check if map
DVD is correct.
A disk other than the map disk is
inserted.
Remove the inserted disk and
insert the correct map disk.
Unable to read DVD correctly.
Check if the DVD is damaged or
dirty.
The data cannot be read due to
scratches and/or dirt on the map
disk.
Check whether there are any
scratches and/or dirt on the map
disk and contact the store of
purchase.
DVD check in process.
The device is now reading the map
disk data.
Wait until a map is displayed on
the screen.
Unable to read data. Temperature
is too high.
The DVD player temperature is
high.
Wait until the temperature has
fallen.
Too many characters were input.
Character entry count for memory
point names beyond capacity.
Decrease the character entry
count and reenter.
No previous points registered.
There are no previously set
destinations.
Register a destination in the
archive and proceed. (Setting a
destination registers it in the
archives.)
Home is not registered. Register in
menu Memory Point.
Your home is not registered as a
memory point.
Register your home as a memory
point and proceed. (Refer to page
101)
No quick access point registered.
Register in menu Memory Point.
A special memory is not registered
for the memory point.
Register a special memory for the
memory point and proceed. (Refer
to page 115)
Messages related to general navigation