Filter
Top Products
25D-Link DCS-5010L User Manual 25
Section 3 - Conguration
Network Setup
Select this connection if you have a DHCP server running on your
network and would like a dynamic IP address to be assigned to your
camera automatically.
Select this connection type if your Internet Service Provider (ISP)
or network administrator has provided you with a static or xed IP
address and other network information for your camera. Click on the
Static IP Address radio button to activate this method.
IP Address: The xed IP address
Subnet Mask: The default value is “255.255.255.0.” Used to determine
if the destination is the same subnet.
Default Gateway: The gateway used to forward data to destinations
in a dierent subnet. Invalid gateway settings may cause the failure
of transmissions to a dierent subnet.
Primary DNS: Primary domain name server that translates names to
IP addresses.
Secondary DNS: Secondary domain name server to backup the
Primary DNS.
If you need to connect to the Internet using a PPoE connection, click on
the PPoE radio button and enter the username and password provided
to you by your Internet Service Provider or Network Administrator
You may congure a second HTTP port that will allow you to connect
to the camera via a standard web browser. The port can be set to a
number other than the default TCP port of 80. A corresponding port
must be opened on the router. For example, if the port is changed
to 1010, users must type http://192.168.0.100:1010 instead of only
“http://192.168.0.100”.
Enable this setting to congure your camera as a UPnP device in the
network. You can also enable UPnP port forwarding.
Enable this setting to allow your camera to be discovered by the
Bonjour service. You can also specify a Bonjour name for the device.
DHCP:
Static IP Client:
PPoE
Port Settings:
UPnP Settings:
Bonjour
Settings:
This section allows you to congure your network settings.