Filter
Top Products
To enter or exit Valet Mode:
1. Turn the ignition on.
2. Turn the ignition off.
3. Press and release the Valet
switch within 10 seconds.
The status LED will light steadily if you are entering Valet Mode and
will turn off if you are exiting Valet Mode.
You can also activate Valet Mode with the remote transmitter:
1. Open any vehicle door.
2. Press .
3. Press .
4. Press again.
The status LED will light solid if you are entering Valet Mode and
will turn off if you are exiting Valet Mode.
Your system has circuitry to prevent annoying false alarms. This
circuitry prevents repetitive trigger sequences due to faulty door
pinswitches or environmental conditions such as thunder, jack-
hammers, airport noise, etc.
Here's how it works: If the alarm is triggered by the same sensor
or switch three times within a 60 minute period, your system inter-
prets this pattern of triggers as false alarms. After the third trigger,
False Alarm Prevention Circuitry
Remote Valet
DRW-35
11
©
2000 Directed Electronics, Inc.