Filter
Top Products
28
pin programming
A PIN code can have one to four digits; each digit can be from 0-9.
Programming Procedure
1. Enter the feature location in the installer programming grid.
2. Immediately press and release of the PlainView 2 Valet
switch.
3. Select each digit by pressing 1-9 times, and then press
to enter the number into the system. To enter a zero,
press only.
To program a PIN code of 1032:
1. Press and release once and once. You will
hear one chirp.
3. Press and release once. You will not hear a chirp
after programming a zero.
5. Press and release three times, and then press
once. You will hear three chirps.
6. Press and release two times, and then press
once. You will hear two chirps.
4. Wait for two siren chirps after a five second pause or five
seconds after the last digit has been entered if using less
than four digit code number.
5. Turn off the ignition; the siren will chirp three times.
6. The programming mode is now exited.
nnoottee::
A PIN code cannot begin with a zero.